AAP Elite S series Uživatelský manuál stáhnout pdf (Strana 25)

current system alarms. If a zone LED or LED’s are On then this indicates

system alarms that have not yet cleared. The zone LED’s 1-8 are pre-

defined as to what system alarm they will display. These system alarm

indications are shown in the table below. Following the display of current

system alarms the panel will then sequence through the 255 historical

memory events starting at the most recent event. The second table shows

the alarm events that can be displayed in memory mode and what indica-

tors are used to show them. Please remember to refer to the keypad refer-

ence drawing on page 30 for the equivalent symbols on the OEM LED

keypad.

The other main difference between the standard LED keypad and the

OEM LED keypad is the operation of the MAINS (AC Fail) and BATTERY

(Battery Low) LED’s.

On the standard LED keypad the LED’s are always illuminated and they

flash when there is a problem but the mains and battery symbols on the

OEM LED keypad are off if everything is OK and flash if there is a prob-

lem.

LED #1

Battery Low

LED

Radio Pendant Battery Low

LED #2 Mains, 12V Fuse or Output Failure

LED

Supervised Detector Failure

LED #3 Telephone Line Failure

LED

Sensorwatch or Delinquency Alarm

LED #4

Radio Detector Battery Low

LED

Dialler Kiss-off Failure

CURRENT SYSTEM ALARMS

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 31 32

Žádné komentáře

AAP Elite S series Uživatelský manuál Strana 25